Filter
Top Products
Extron • System 4
xixi
xixi
xi
Switcher Series • User’s Manual • P/N 68-428-02 Rev. C
Configuration and ConnectionsSony LCD Compatible Installation
5. Verify that the IR Comm Adapter is configured correctly (refer to the
IR Comm
Adapter User’s Guide
). Connect the 3.5 mm male plug end of the supplied
cable into the “OUT” jack of the IR Comm Adapter. Connect the other end of the
cable into the “CONTROL S IN” port of the projector. If a hardwired remote or
host controller is being implemented, connect that device to the “IN” jack of the
IR Comm Adapter.
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
into the PJ Comm port on the System 4xi. Connect the other end of the cable
into the IR Comm Adapter’s “PROJECTOR CONTROL” port.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable into the System 4xi output Connect the 15-pin male end of the RGBS/HV
cable into “INPUT A” of the projector.
Use the illustration below as a guide when connecting the System 4xi to a Sony
LCD projector. Refer to Sony documentation to continue the installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4
xi
. See page 2-5 for cabling guidelines.
Page 2
15-pin
CC 50'
Female
9-pin
15-pin
IR Comm Adapter
26-483-01
Hardwired remote/
host controller
Cable
26-485-01