Sony 26-473-01 Car Video System User Manual


  Open as PDF
of 7
 
Extron • System 4
xixi
xixi
xi
Switcher Series • User’s Manual • P/N 68-428-02 Rev. C
Sony LCD Compatible Installation Configuration and Connections
Connecting System 4
xixi
xixi
xi to Sony Projector under RS-232 Control
If the System 4xi is already configured for a Sony RS-232 projector, go to step
4. If it is not set up correctly, it will be necessary to change switch settings on the
System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Sony RS-232 projector. Apply power to the System 4xi
and do the following:
a. Press to display the MENU SELECT on the LCD screen.
b. Press or to step to Menu 8.
c. Press to select this menu.
d. Press or to display the configuration. The example to the left is general,
yours will show the System 4xi model name, the software version and the
following information:
PRJ = SONY
PRJ BAUD = 38400
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the
System 4
xi
User’s Manual
to remove the
System 4xi cover. Then go to page 2-4 and refer to the configuration below to
set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.
Config
as
Model
SW1
SW2 SW3 SW4 SW5 SW6
PROJ
CABLE
Comm
Adapter
1 2 3 4
Sony RS-232
off on off on
00
8E0
J15
26-473-01
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but not powered on.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
Page 5
(Note: Information depends on
S
y
stem 4 setup.
)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]
}
SW1
ON
SW4
SW3
SW5
J15
3
4
1
2
SW2
SW6
 previous