Sony FWD-S55H2 Car Satellite TV System User Manual


 
31
GB
GB
Setup Settings
For the setting method, see the section of “Overview of the Menus” (page 24).
Menu Function and operation
Language
Select from the language settings shown. Select “English”, “Deutsch”, “Français”,
“Español”, “Italiano” or “ ”.
Timer Setting
You can adjust time, display the built-in clock, or set the timer to make the display
power on/off at a predetermined time.
If the main power switch is left turned off or the AC power cord removed for a long
time, the built-in clock may lose or gain time significantly.
In this case, reset the clock to the right time.
Clock Set
Sets the day of the week and the hour of the day.
Date Set
Sets the date (year, month, date). The day is automatically set.
Time Set
Sets the time.
Clock Display
Select “On” or “Off”. If you select “On”, when the remote control’s DISPLAY
button is pressed, it shows the current time which was set.
On/Off Timer
Sets the day of the week and the hour of the day.
This cannot be used unless the “Timer Setting” has been set.
ECO Mode
Reduces power consumption by changing the brightness of the backlight. Selecting
“High” reduces power consumption more than “Low”.
Off/Low/High
Status Display
Select “On” or “Off”. If you select “On”, the input signal and “Aspect” setting
information show on the screen for about 5 seconds when the display is turned on.
When you switch the input signal, the input signal information shows for about 5
seconds.
Tip
You can display the input signal and “Aspect” setting information by pressing
DISPLAY button on the remote control.
Speaker Out
Select “On” or “Off”. If you select “On”, sound is output from the speakers.
Advanced Setup
Enter more detailed settings.
Control Setting
This menu is used for settings of operation of the display and the remote control.
Index Number
You can change the index number of the display if necessary. Select to set the index
number of the display with F/f buttons on the display, and press button to
confirm the setting.
The “Index Number” cannot be set with the remote control.
Note
Note
Note