Filter
Top Products
NSR-1000 Series v1.1.1 Release Note
registration. (V1
1N:461)
３-１１ Action Configuration
・ N/A
３-１２ Schedule Configuration
・ If user sets
the schedule record of following cameras with the ‘Automatic
Record Configuration’, the codec setting shall be not MPEG4 but JPEG. If user
needs to change the setting, please select the codec on ‘Video’ tab in the Device
menu. (VT1:1690)
SNC-CM120, SNC-CS20, SNC-DF85, SNC-DM110, SNC-DM160, SNC-DS10,
SNC-DS60
・ If user changes the ‘Storage Setting’ of the camera during recording, new
storage setting has not been available for recording. Following steps are
recommended to change the storage setting. (VT1:1646)
1. Disable the schedule setting. (Uncheck ‘Enable’ check box on the top of the
schedule configuration window)
2. Change ‘Storage Setting’
3. Enable the schedule setting. (Check ‘Enable’ check box on the top of the
schedule configuration window)
・ If user enables audio setting to the camera during recording, it is not available
to record audio of it. It is necessary to enable audio setting before starting to
record in order to record audio. (VT1:1643)
・ If user adds the camera to the existing schedule, the ‘recording cameras box’
may be blank. In this case, this recording schedule is not available. It is
necessary to reacquire settings of cameras with the ‘Adjust to camera
configuration’ button. (VT1:1441)
・ If user changes the system time during recording, the time of recorded data
shall change with this change. There may be problems that the duration
- 15 -