Filter
Top Products
14
and clear frequency station. Repeat to seek more stations in your listening area with a
strong signal.
Mono/ Stereo control (in FM radio mode)
Press the VOLUME knob / SEL button until the display shows “ST ON” or “ST OFF” (MONO).
Turn the VOLUME knob to switch between ON or OFF.
Improvement of reception of distant stations can be done by selecting “MONO” operation
which may cut down some reception noise.
Automatic store, Automatic scan
During listening to the radio press and hold the F / PS button for more than 3 seconds. The
receiver will automatically scan and save stations for the AM/FM bands.
Press the F / PS button once in Radio mode to scan the stations in all bands.
Press APS button on the RC to scan all preset stations in the memory of the current
band. To stop preset scan, press this button again.
Programming tuner stations
You can store up to a total of 30 radio stations in the memory (18 FM, 12 AM), manually or
automatically.
To store a station:
Select a band (if needed).
Select a station by / buttons.
Press and hold a numbered button (1-6) which you want store the station for at least 2
seconds.
To recall a station:
Select a band (if needed).
Press a Preset button (1-6) briefly to recall the stored station.