SoundMax SM-CMD3011 Car Stereo System User Manual


 
25
Back view camera
This unit is equipped with back view camera output. The camera is used to observe the situation behind the
vehicle when you are backing the car.
Please connect your back view camera with the back car video input. And connect the detecting wire for
back a car with the rear gear light. Rear view camera picture will be enabled when you are backing the car.
Handling discs
 Dirty, scratched or warped discs may cause skip ping or noise.
 Handle the disc only by the edges. To keep clean do not touch its surface.
 Discs should be stored in their cases after use to avoid scratches.
 Do not expose discs to direct sunlight, high humidity, high temperature or dust.
 Prolonged exposure to extreme temperature can wrap the disc (such as leaving the discs in your car
during summertime).
 Do not stick or write anything on either side of disc. Sharp writing instruments, or the inks used in some
felt-tip pens, may damage its surface.
 Do not touch the unlabeled side. Do not attach any seal, label or data protection sheet to either side of a
disc.
Cleaning
Cleaning the cabinet
Wipe with a soft cloth. If the cabinet is very dampen (not dropping wet) the cloth with a weak solution of
soapy water, and then wipe clean.
Cleaning discs
Fingerprints should be carefully wiped from the surface of disc with a soft cloth. Unlike conventional records,
compact discs have no grooves to collect dust and macroscopic dirt, so gently wiping them with a soft cloth
should remove must panicles. Wipe in a straight motion from the center to the edge.
Never use thinner benzine, record cleaner or anti static spray on a compact disc. Such
chemicals can damage its plastic surface.