Filter
Top Products
A Word About Subwoofer Placement
Subwoofers operate at extremely low frequencies, which are primarily omni-directional. Keep in
m
ind that frequency response and output level can be drastically influenced by placement,
depending on the acoustic properties of the listening room. Typically, the optimum location for
a subwoofer is in a front corner of your listening room. This location will usually offer the
greatest output levels and optimum low frequency extension. The worst location for a
subwoofer is typically far away from any walls, close to the center of your room and near an
opening or doorway. Avoid these locations when possible. When using a pair of SC subwoofers
in stereo, it is preferable to place each subwoofer by the satellite of the same channel. Typically,
a minimum distance of one to two feet from your TV to the subwoofer will be adequate to avoid
any magnetic interference.
Remember that the built-in 7 band EQ will help to get the most performance out of your
subwoofer no matter where it is placed.
Caution!
This amplifier has electronics built into the cabinet. Do not place the amplifier next to sources
of heat such as furnace registers, radiators, etc. Likewise, do not place the amplifier near
sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power cord
should be routed in such a way that it will not be walked on, pinched or compressed in any way
that could result in damaging the insulation or wire.
Your SC-1250 can control a variety of Velodyne SubContractor Series subwoofers as well as generic passive
subwoofers. Special internal software settings are designed to maximize performance and reliability depending
on the model of subwoofer being controlled, so it is important to match the SC-1250 amplifier with the
subwoofer(s) it is controlling. The SC-1250 comes with a default setting for the SC-10 subwoofer. When the
unit is first powered up, the model being controlled is displayed for 2 seconds on the numeric LED before the
display reverts to the volume setting. The subwoofer to be controlled is shown as follows:
** - The generic subwoofer setting is for passive subwoofers not on the above list. CAUTION: there is no anti-
clipping or anti-distortion protection on this setting.
To change the subwoofer to be controlled, first power down the amplifier using the power switch on the back
panel (DO NOT use the power button on the fr
ont panel). Then, tur
n the switch on while depressing any of
the buttons on the front panel (crossover up or down, or volume up or down). The unit will show the model
it is currently contr
olling. T
o change the model, simply push the crossover up or crossover down buttons and
the model changes on the LED display. Once the desired model is seen on the LED display, simply release the
button. You don’t need to do anything else - the model to be controlled is automatically stored in the SC-1250’s
11
.
www.velodyne.com
SubContractor User’s Manual
Selecting the Subwoofer(s) to be Controlled
Model LED Display
SC-8 8
SC-10 I0
SC-12 I2
SC-15 I5
Model
LED Display
SC-In-W
all (SC-IW)
I
W
SC-In-Floor (SC-IF) IF
SC-In-Ceiling (SC-IC) IC
Generic Subwoofer** GS