Filter
Top Products
Verona CR 43 - Honda
18
Adjusting the local mode sensiti-
vity
In regions with extremely high station densi-
ty, e.g. in Italy, the set allows you to switch
over the station seek sensitivity for the ocal
mode from “High” (adjusted ex works) to
“Low”. “Low” means that station seek tuning
only captures the most powerful stations.
For modifying the local mode:
● press button lo < longer than 8 secs.
The display : shows “L” for “Low”.
By pressing button lo < again longer than
8 secs., the set switches back to “High” (dis-
play : “H”).
When switching off the unit or when removing
the set with the QuickOut handle the set
remains in the last activated mode.
Switching between Stereo and
Mono
If you wish to switch between stereo and
mono:
● keep the lo button < pressed for long-
er than 2 seconds. The stereo symbol
will appear in the display : if the
stereo mode is activated.
The stereo function is activated auto-
matically when you turn your set on.
The set will automatically switch to
mono if reception is poor.
Radio Section
Selection of the Desired Wave-
band
This radio allows you to choose between the
FM, MW and LW wavebands.
FM Selection
● Briefly press the FM•T rocker switch
>. “FM” is displayed in the display (for
Frequency Modulation).
MW or LW Selection
● Briefly press the M•L rocker switch =.
An “M” (for MW), or an “L” (for LW) will
then appear in the display.
If you wish to switch between MW and LW:
● press the M•L rocker switch = again.
The following instructions apply for all wave-
bands, as long as not otherwise indicated.
Automatic Station Tuning
Tuning of Subsequent Station
● Press rocker switch / 2 up. The
radio will automatically seek the next
station.
Tuning of Previous Station
● Press rocker switch
/ 2 down. The
radio will automatically seek the previ-
ous station.
If the rocker switch
/ 2 is held
down/up, the seek operation continues
to be carried out quickly in the corre-
sponding direction.
Manual Tuning
It is also possible to tune in stations “by hand”
with this radio:
● Press rocker switch <</>> 3 to the left
or to the right. The frequency band is
scanned in small steps.
Adjusting the Station Seek
Sensitivity
You may also modify the sensitivity of the
automatic station seek operation.
For this:
● press lo rocker switch <.
If “lo” is indicated, only stations with
good reception conditions are captured
(lower sensitivity).
If “lo” is not indicated, stations with a
weaker reception are also captured
(higher sensitivity).