Filter
Top Products
11
Connecting Speakers
The Speaker Terminals are located on the rear panel.
There are two SPEAKER terminals. Be sure to connect the
left channel (L), right channel (R), “+” (red) and “--” (black)
properly.
• Before connecting the speakers, make sure that the CDG-
6000RV is disconnected from the power source.
• Do not let the bare speaker wires touch each other or
another metal part of this unit. This could damage the
CDG-6000RV and/or the speakers.
Determining the proper way to connect the speaker
cables:
The speaker cable is a pair of insulated cables running side
by side. One cable is colored or shaped differently , perhaps
with a stripe, groove or ridges.
1. Connect one end of the striped (grooved, ridged, etc.)
cable to the “+” (red) terminal on the rear panel of the
CDG-6000RV.
2. Connect the other end of the striped (grooved, ridged,
etc.) cable to the “+” (red) terminal on the speaker.
3. Connect one end of the “plain” (NO stripes, grooves,
ridges, etc.) cable to the “--” (black) terminal on the rear
panel of the CDG-6000RV.
4. Connect the other end of the “plain” (NO stripes, grooves,
ridges, etc.) cable to the “--” (black) terminal on the
speaker
Preparing the Speaker Cable
You can either use an exposed speaker wire or Banana Plug
speaker cable.
Exposed
Speaker W
ire
1. Remove approximately 3/8” (10mm) of insulation
2. Twist the exposed wires together to prevent short circuits
3. Loosen the knob on the speaker terminal
4. Insert the bare wire
5. Tighten the knob until the wire is secure
Getting Connected cont.