Filter
Top Products
12
Getting Connected cont.
Connecting a Powered Vocal Monitor
The HV-1200 has two types of connections for mic-only
output. This is for compatibility with different types of powered
vocal monitors. See your powered vocal monitor instruction
manual to see if you need an XLR or ¼” cable.
What you will need:
• Powered Vocal Monitor
• XLR or ¼” cable
To connect a Powered Vocal Monitor to the HV-1200
1. Connect one end of the XLR or ¼” cable to the rear
panel of the HV-1200.
2. Connect the other end of the XLR or ¼” cable to the
input on the Powered Vocal Monitor.
Connecting to TVs/Video Monitors using the RCA Video (yellow) Outputs
There are three video outputs on the rear panel of the HV-
1200. All three connectors output the same video signal
which is selected by the AV selector button on the front
panel.
What you will need:
• Up to 3 TVs/Video Monitors with RCA video inputs
• RCA video cable(s) (yellow)
To connect TVs/Vi
deo monitors to the HV-1200
1. Connect one end of an RCA video cable to an RCA
video OUT jack on the HV-1200 rear panel.
2. Connect the other end of the RCA video cable to the
RCA video input on the TV/Video monitor.
3. Make sure the TV/Video monitor is set to the correct
video input. Consult the TV/Video monitor’s user
manual for the necessary instructions.
4. Repeat steps 1-3 for each additional TV/Monitor.