Filter
Top Products
13
Getting Connected cont.
Connecting External Players to the HV-1200
There are four Audio/Video input channels on the rear
panel of the HV-1200. This allows you to connect up to
four external players such as DVD players and CD+G
players to the HV-1200. You can switch between these
input channels using the AV selector button on the front
panel.
What you will need:
• Up to 4 external players with RCA outputs
• RCA Audio/Video cable(s) (yellow, red, white)
To connect
external players to the HV-1200
1. Connect one end of an RCA Audio/Video cable to an
RCA Audio/Video OUT jack on the external player.
NOTE: Some players, such as CD players, do not
have video outputs. In this case, use only the Red
and White RCA connectors.
2. Connect the other end of the RCA Audio/Video cable
to an RCA input channel on the HV-1200 rear panel.
3. Repeat steps 1-2 for each additional player.
Connecting an External Vocal Effects Device
The HV-1200 has an effects loop which allows you to add additional effects to the microphone channels.
What you will need:
• External Effects Device
• Two ¼” Cables
To connect an External Effects Device to the HV-1200
1. Connect one end of one ¼” cable to the mic loop SEND jack on the rear panel of the HV-1200.
2. Connect the other end of this cable to the input on the external effects device.
3. Connect one end of the next ¼” cable to the output of the external effects device.
4. Connect the other end of this cable to the mic loop RETURN jack on the rear panel of the HV-1200.
NOTE: Your effects device may have a different type of input and output jack. You may need a different type of
cable or an adapter to make this connection. Refer to your effects device instruction manual.
Connecting an External Music Effects Device
The HV-1200 has an effects loop which allows you to add additional effects to the music signal.
What you will need:
• External Effects Device
• Two Paired ¼” Cables
To connect an External Effects Device to the HV-1200
1. Connect one end of one paired ¼” cable to the music loop SEND jack on the rear panel of the HV-1200.
2. Connect the other end of this cable to the input on the external effects device.
3. Connect one end of the next paired ¼” cable to the output of the external effects device.
4. Connect the other end of this cable to the music loop RETURN jack on the rear panel of the HV-1200.
NOTE: Your effects device may have a different type of input and output jack. You may need a different type of
cable or an adapter to make this connection. Refer to your effects device instruction manual.