Filter
Top Products
5
Before installing the receiver permanently, fit it in the approximate place inyour car,and connect the
equipment according to the speakersand electrical connections.When
your system is operated properly,(preferably with the
car engine running), follow theinstructions
for permanent installation
of your system.
1) Adapter
(not supplied)
2)Bend over tabs
of half sleeve
(supplied)
Half sleeve
(supplied)
3) Two wrenches for releasing
the unit (supplied)
INSTALL THE UNIT
1)Install half sleeve, can be with or
without adapter.It will fitbetter
with adapter.
2)Bend over some tabs tosecure
the half sleeve inside ofdash.
3) Support strap to be strutted
under dash, secure this strip to
avoid skipping of disc.
Insert removal wrench into thesmall
gap on the right side of theunit and pull
the unit slightly out onthe sameside,
then release the wrench. Repeatthe
same action for the left side. By now,
you can remove the unitand unplug
the wires connector.
REMOVE THE UNIT
Installation