![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/d/09/d09928e4-a8ff-49e0-8a0a-69a5cd80fd16/d09928e4-a8ff-49e0-8a0a-69a5cd80fd16-bg92.png)
146 CHAPTER 9: CONFIGURING THE CALL PROCESSOR
CAUTION: If you add one or both of these services using the method
described in this section and later you run the
vcx-reconfigure
command, the list of services provided in
vcx-reconfigure will override
those defined using remoteCli. Furthermore, if you reconfigure your VCX
system using remoteCli and subsequently upgrade the system to a newer
release, the upgrade process will not recognize the remoteCli
reconfiguration. You will have to manually reconfigure your system using
remoteCli to match your previous configuration. Consult with your 3Com
representative before using the remoteCli to configure Accounting
services or Authentication and Directory services on your VCX system.
Adding Primary and
Secondary
Accounting Servers
To add a primary Accounting server using the remoteCLI interface:
1 Log onto the server hosting the primary Call Processor.
2 Navigate to the /opt/3com/VCX/callprocessor/remoteCli/bin.
3 Start the remoteCLI interface:
./remoteCli -callprocessor
4 At the remoteCli prompt (>) enter:
config acctc use=false
config accts pri=1 IpAddress=<IP address of primary
Accounting server>
config accts pri=1 LocalIpAddress=<IP address of call
processor>
config acctc use=true
5 The interface lists the IP address of the new Accounting server.
6 To exit the remoteCLI interface, enter:
exit
To add a secondary Accounting server using the remoteCLI interface:
1 Log onto the server hosting the primary Call Processor.
2 Navigate to the /opt/3com/VCX/callprocessor/remoteCli/bin.
3 Start the remoteCLI interface:
./remoteCli -callprocessor
4 At the remoteCli prompt (>) enter:
config acctc use=false