Getting Started
Steps for Setting Up Eye-Diagram Analysis
the instruments’ front panels, follow the instructions shown. Otherwise,
proceed with “If you have not already connect the cables to the instruments’
front panels, follow the instructions shown. Otherwise, proceed with “If you
have not already connect the cables to the instruments’ front panels, follow the
instructions shown. Otherwise, proceed with .” on page 1-21.” on page 1-21.”
on page 1-22.” on page 1-22.
Step 4. Set Up the Measurement Conditions
Select the Mode
1 To select the mode, press:
Setup, diagram, EYE, EYELINE, or PATTERN
Select Single or
Continuous
Sweeps
2 Press the left-side Trg,Cal softkey.
3 Select one of the following sweep states:
• Press SINGLE to select single sweeps. Each additional press of this softkey
triggers another sweep.
• Press CONT STOP CONT
to select continuous sweeps.
• Press CONT STOP STOP
to stop the sweeps.
Select Trigger
Source
4 Press the left-side Setup softkey.
5 Press CH2.
• If the pattern generator’s CLOCK OUT signal is connected to the RF INPUT
2 connector, press CLK OUT.
• If the pattern generator’s TRIGGER OUT signal is connected to the RF IN-
PUT 2 connector, press TRG OUT.
