Invoking Auto Scan:
To start Auto Scanning, key in the following Hotkey combination:
1. Invoke HKM (see p. 51).
2. Press [A].
After you press A, you automatically exit HKM, and enter Auto Scan
Mode, and Auto Scanning begins.
w While you are in Auto Scan Mode, you can pause the scanning in order
to keep the focus on a particular computer either by pressing P or with a
Left Click of the mouse. During the time that Auto Scanning is paused,
the Command Line displays: Auto Scan: Paused.
Pausing and Exiting are the two ways to stop scanning and keep the focus on
a particular computer. If you intend to continue scanning after a brief stop,
Pausing is more convenient than Exiting Auto Scan Mode completely.
This is because when you Resume scanning after Pausing, you start from
where you left off. On the other hand, if you Exit and then restart Auto
Scan, you start over from the very first computer on the installation.
To Resume Auto Scanning after you Pause, press any key or Left Click.
Scanning continues from where it left off.
w While Auto Scan Mode is in effect, ordinary keyboard and mouse functions
are suspended - only Auto Scan Mode compliant keystrokes and mouse
clicks can be input. You must exit Auto Scan Mode in order to regain
normal control of the console.
3. To exit Auto Scan Mode press [Esc] or [Spacebar]. Auto Scanning stops
when you exit Auto Scan Mode.
2004-08-04
54
