PN0108 User Manual
60
Firmware Upgrade Recovery
Single Station Recovery
To perform a firmware upgrade recovery, do the following:
1. Power the PN0108 OFF.
2. Slide the Firmware Upgrade switch to the RECOVER position.
3. Power the PN0108 back ON.
4. Repeat the upgrade procedure from the beginning.
5. After the upgrade, power the PN0108 OFF.
6. Slide the Firmware Upgrade switch to the NORMAL position.
7. Power the PN0108 back ON.
Daisy Chained Station Recovery
If any of the Stations on a daisy chained installation fails to complete the
upgrade procedure successfully:
1. Disconnect it from the chain.
2. Connect your computer to its PON In port (with the PON Cable).
3. Perform the upgrade recovery procedure on it as for a single station
recovery.
After the upgrade completes, connect it back into the chain.
