7. R code
------------------------------------------------------------------------------------------------
----------------------------------------------------------------------------------------
7
- 38
Example
Operation method
After inputting [1], if press [SET] key, it will be appeared on the screen as followings
After inputting Port No. if press [SET] key, it will be appeared on the screen as
followings
After inputting the No. of Lower voltage with a numeric key, if press [SET] key, it
will be appeared on the screen as followings.
After inputting the No. of Upper voltage with a numeric key, if press [SET] key, it
will be appeared on the screen as followings.
If you choose [0] for reference point setting, other parameters (reference X, reference
Y, reference Z) will be 0 automatically, and complete input. If you choose [1] for
reference point setting, there will be a message as followings.
S1 S2
S3
F001:M30[1,1.00,3.00,0,0,0,0]
S4
S5 S6:End
Option board
Stop,decel. section
Analog1 Voltage
: 2.00V
Enter
ort No
1 - 2
>M30=
Service System Rel.WAIT Cond Set
In
ut minimum volta
e.
-10.0 - 10.0
>M30
1
Service System Rel.WAIT Cond Set
In
ut maximum volta
e.
-10.0 - 10.0
>M30=1
-5.00
Service System Rel.WAIT Cond Set
Set "reference
oint settin
"
0 - 1
>M30=1
-5.00
5.00
Service System Rel.WAIT Cond Set
