9-6
■ Memory scan operation
qPush several times to close a multi-func-
tion screen, if necessary.
wSelect memory mode.
ePush [F-5•SCAN] to select the scan screen.
rSet [SQL] open or closed.
• See page 9-2 for squelch condition.
tPush [F-1•MEMO] to start the memory scan.
•“ ” and decimal points blink while scan-
ning.
yWhen the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
uTo cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for memory scan to start.
■ Select memory scan operation
qPush several times to close a multi-func-
tion screen, if necessary.
wSelect memory mode.
ePush [F-5•SCAN] to select the scan screen.
rSet [SQL] open or closed.
• See page 9-2 for squelch condition.
tPush [F-5•SEL No.] several times to select the se-
lect scan number from ★1, ★2, ★3 and ★1/★2/★3.
yPush [F-1•MEMO] to start the memory scan.
•“ ” and decimal points blink while scan-
ning.
uPush [F-3•SELECT] to start select memory scan;
push [F-3•SELECT] again to return to memory scan,
if desired.
•“ ” blinks instead of
“” during select memory scan.
iWhen the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
oTo cancel the scan, push [F-1•MEMO].
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated as
select memory channels, as well as the same select
scan channel number, for select memory scan to
start.
