Invacare Adjustable ASBA Seat Manual

A SERVICE OF

next previous

SECTION 7—POWER ELEVATING LEGRESTS

Adjustable ASBA Seat 40 Part No 1143238

Removing/Installing the Power Elevating Legrest

Harness

NOTE:Forthisprocedure,refertoFIGURE 7.9onpage 41.

Removing

1. Unplugthepowerelevatinglegrestconnectorfromtheharness.

2. UnplugtheharnessfromtheTRECMorDLIAM.

3. Cutthetie‐wrapsecuringtheharnesstotherearharnesswirebracket.

4. Removethetwocapscrewsandlocknutssecuringtheharnessconnectortothefront

harnesswirebracket.

Installing

1. Ifpowerlegrestswerenotpreviouslyinstalled,performthefollowingsteps:

A. Removethehexscrewandwashersecuringthefrontofthereararmsockettothe

seatframe.

B. Installtherearharnesswirebracketontothefrontmountingholeonthereararm

socketusingthehexscrew.

NOTE:ThehexscrewwillinstallintotheT‐nutintheseatframe.

C. Installthehexscrewthroughthewasherandfrontharnesswirebracketandinto

theT‐nutintheseatframe.

D. RepeatSTEPSA‐Cfortheoppositesideofthewheelchair.

2. Securethepowerelevatinglegrestconnectortothefrontharnesswirebracketusing

thetwocapscrewsandlocknuts.

3. Tie‐wraptheharnesstotherearharnesswirebracket(Detail “A”).

4. PlugtheharnessintotheTRECMorDLIAM.

5. RepeatSTEPS2‐4fortheoppositesideofthewheelchair.

6. Installthepowerelevatinglegrests.RefertoInstalling/RemovingthePowerElevating

Legrestsonpage 34.