1.10
Getting started
4
Adjust the side guide and the rear
guide for the paper by sliding them.
Note: Slide the side guide by press-
ing the green part.
Slide the rear guide by press-
ing both sides of it.
5
Close the cassette.
Loading the large capacity cassette (Option)
1
Pull the cassette toward you.
2
Push down the bottom plate inside the cassette so it clicks and the plate and
the bottom of the cassette are even.
3
Insert the paper into the cassette
along the right side with face up.
Note: Make sure the stack of paper
isn’t higher than the limit
mark.
4
Insert the paper into the cassette
along the left side with face up.
Note: Make sure the stack of paper
isn’t higher than the limit
mark.
5
Close the cassette.
Changing the paper size
You should tell the paper size to the machine, when you change the paper size. Set
the paper size after loading new papers in the cassette.
Note: When you want to change the paper size of the 2nd, 3rd, 4th or 5th paper
cassette, please contact your authorized Muratec dealer.
Changing the paper size of the multi purpose cassette
You can change the paper size of the multi purpose cassette only by moving the
guides in the cassette (see page 1.9).
To set the paper size:
1
When you put papers in the cassette, the
LCD
shows:
When using the standard paper size:
(1) Select the paper size using the cursor key.
(2) Press [Enter].
When using the non standard paper size:
(1) Press [Other].
(2) Select the paper size using the cursor key.
(3) Press [Enter].
Note: If you want to go back to the standard
paper select display, press [Standard].
When using the special sized paper:
(1) Press [Other].
(2) Select “Custom” using the cursor key.
Note: You can register three types of special
size as you want.
(3) Press [Enter].
(4) Enter the horizontal and vertical size of the paper using the numeric keypad.
Note: You can also enter the paper size using and of the cursor key.
Note: To change Horizontal / Vertical, use and of the cursor key.
(5) Press [Enter].
