A SERVICE OF

logo

Open as PDF
next previous
26 Finalizing the Installation
1. Move to the front of the unit and crouch down, facing the screen.
2. Look underneath the pen tray and locate the electronics tray. You’ll see a large access hole
covered with a plastic cap on the right side of the electronics tray.
3. Remove the plastic cap that covers the access hole. If the cap seems tight, insert the
screwdriver into the small opening at the top of the cap and carefully pry the cap off.
4. Loosen and tighten the nut inside the access hole with the supplied 7/16" nut driver to adjust
the image vertically.
5. Replace the plastic cap you removed in step 3.
6. If the image requires further fine adjustment (1/4" or less), perform the procedure immediately
below.
To move the image vertically
CAUTION
Do not turn the nut more than two full turns in a clockwise direction. Turning the
nut too far clockwise may crush the spring that is an essential part of the
adjustment mechanism.
Move Image Up or Down
Electronics Tray