Setup Guide
19
Chapter
3
EtherTalk, LocalTalk,
and TokenTalk
Configuration
Configuration overview
N
O
T
E
The printer’s AppleTalk connection works with Macintosh system software 7.0,
7.1, 7.5, 7.6, 8.0, 8.1, and 8.2.
The configuration procedure for LocalTalk, EtherTalk, and TokenTalk consists of
two simple steps:
1.
Print the Configuration Page. It reports the printer’s default name,
which you need for EtherTalk and TokenTalk configurations. For
information on printing a Configuration Page, see “Printing a
Configuration Page” on page 2.
2.
Verify that the printer is in the Chooser. See “Finding the printer’s
name in the Chooser” on page 20.
■ If the printer is not in the Chooser, see the PhaserShare Networking
Manual on the printer’s CD-ROM.
■ If the printer is in the Chooser, you may want to change the
printer’s name or zone. For information on these procedures, see
the PhaserShare Networking Manual on the printer’s CD-ROM.
