Helix 7
GB
System Description
3.2 Component Description - without circulation
Item Description Function
A Component Pump A In a two-component system, Component Pump A typically pumps the ISO or activator material.
B Component Pump B In a two-component system, Component Pump B typically pumps the resin material.
C Heater Block Materialowsfromthesupplycontainersintotheuidpumps,wherethematerialispressurized
to the desired pressure(s), based on the Control Panel settings. The heater block heats the material
on its way to the material pumps.
D Control Panel The control panel contains all of the system controls that allow the sprayer to function properly, as
well as being the main display panel that gives information about the system.
E PRIME/SPRAY knob The PRIME/SPRAY knob directs material to the spray hose when in the SPRAY position and to the
prime hoses when in the PRIME position. Turning the PRIME/SPRAY knob will relieve any pressure
built up in the system.
F Prime hoses When the PRIME/SPRAY knobs are set to PRIME, spray material will circulate into the Component
pumps and then out of the prime hoses.
G Inlet valves The inlet valves allow material to be drawn from the material containers into the system. They can
be turned o in order to prevent material from entering the system.
H Supply hoses The two supply hoses deliver uid from the supply drums to the Component pumps.
I Dual heated hose The dual heated hose delivers spray material from the two Component Pumps to the spray gun.
J Transfer pump The two transfer pumps pump material from the supply containers, into the supply hoses and then
to the Component Pumps. The transfer pumps are powered by an air compressor.
Desiccant dryer The Desiccant dryers remove any moisture that is present in the air pockets left by the removal of
material from the supply drums.
L Transfer pump air hose The transfer pump air hose delivers air from the compressor to the transfer pumps.
29.4” (747 mm)
28” (711 mm)
47.2” (1199 mm)
26.7” (678 mm)
23.2” (589 mm)
3.3 Clearance diagram
When determining the location of the Helix system,
use the diagram below to determine space clearance
and mounting hole dimensions.
