English English
© Titan Tool Inc. All rights reserved. 7
Solid Green
When the pressure indicator is solid green, the sprayer is operating
between 1901 and 3300 PSI. A solid green pressure indicator means:
• The sprayer is at the proper pressure setting for spraying oil-
based and latex house paints
• The sprayer is operating at peak performance at a high
pressure setting for airless spraying
Motor Running Indicator
The Motor Running indicator is on when the motor is commanded to
run. This indicator is used by service centers to troubleshoot motor
problems.
Pressure Relief Procedure
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for
cleanup.
1. Make sure the pressure control knob is in its OFF position in
the white zone.
2. Turn the PRIME/SPRAY valve to the PRIME
position.
3. Trigger the gun to remove any pressure
that still may be in the hose.
4. Lock the gun by ipping the trigger lock
into lock position (see spray gun manual).
Injection hazard. Do not spray without the tip guard
in place. NEVER trigger the gun unless the tip is
completely turned to either the spray or the unclog
position. ALWAYS engage the gun trigger lock before
removing, replacing or cleaning tip.
Spraying Technique
The key to a good paint job is an even coating over the entire surface.
This is done by using even strokes. Keep your arm moving at a
constant speed and keep the spray gun at a constant distance from
the surface. The best spraying distance is 10 to 12 inches between
the spray tip and the surface.
Keep stroke smooth and at an even speed.
Even coat throughout
Approximately
10 to 12 inches
Keep the spray gun at right angles to the surface. This means moving
your entire arm back and forth rather than just exing your wrist.
Heavy Coat
Do not ex wrist while spraying.
Light CoatLight Coat
Keep the spray gun perpendicular to the surface, otherwise one end
of the pattern will be thicker than the other.
The spray gun should be triggered by turning it on and o with each
stroke. This will save paint and avoid paint buildup at the end of the
stroke. Do not trigger the gun during the middle of a stroke. This will
result in an uneven spray and splotchy coverage.
Proper way to trigger the spray gun
Aproximately
10 to 12 inches
Keep stroke
even
Start stroke End strokePull trigger Release triggerKeep steady
Overlap each stroke by about 30%. This will ensure an even coating.
When you stop painting, lock the gun trigger lock, turn the pressure
control knob counterclockwise to its lowest setting and set the
priming knob to PRIME. Turn the motor switch to OFF and unplug
the sprayer.
