© Titan Tool Inc. All rights reserved. 15
S
olution
1. Fluid not atomizing correctly:
I
ncrease fluid pressure. Change to smaller
t
ip orifice size. Reduce fluid viscosity.
R
educe hose length. Clean gun and
filter(s). Reduce number of guns using
pump.
1
. Same as above.
1. Clean or replace nozzle tip.
1. Inspect for suction hose leak.
2. Change to a smaller tip orifice size. Install
pulsation dampener in system or drain
existing one. Reduce number of guns using
pump. Remove restrictions in system; clean
tip screen if filter is used.
1. Replace tip.
2. Increase pressure. Thin material. Change
nozzle tip.
C
ause
1. Inadequate fluid delivery
1
. Inadequate fluid delivery
1. Plugged or worn nozzle tip
1. Suction leak
2. Pulsating fluid delivery
1. Worn tip
2. Fluid too heavy for tip
Spray Patterns
P
roblem
Tails
H
our glass
Distorted
Pattern expanding and
contracting (surge)
Round pattern
Troubleshooting
