TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-20
4.4.2.7 ETH-IPoE
If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH interfaces.
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to IPoE
over ATM interface (see section 4.4.2.2
ATM-EoA-IPoE). The difference is that you have to
set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding
screen see Figure 4-10).
4.4.2.8 ETH-Bridge
If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of 4.4.1.2
ETH interfaces.
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to Bridge
over ATM interface (see section 4.4.2.3
ATM-EoA-Bridge). The difference is that you have to
set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding
screen see Figure 4-10).
)
Note:
The Bridge option only display on the screen of Figure 4-20 when VLAN MUX Mode is selected for
Connection Mode on the screen of Figure 4-6.
4.4.3 LAN
Choose “Advanced Setup”Æ“LAN”, and you will see the LAN screen (shown in Figure 4-21), the
section allows you to configure the Router’s LAN ports settings.
28
