Replacing
2. Line up opening in the reflector
bowl with the surface unit
receptacle.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle.
4. Push the surface unit terminal into
the receptacle. When the terminal
is pushed into the receptacle as
far as it will go, the surface unit will
fit into the reflector bowl.
CAUTION: Reflector bowls reflect heat back to the utensils on the
surface unlts. They also help catch spills. When they are kept clean,
they refleot heat better and look new longer.
If a reflector bowl gets dlsoolored, some of the utensils may not be
flat enough, or some may be too large for the surface unit. In either
Case, some of the heat that’s meant to go Into or around a ulensll
goes down and heats the reflector bowl. This extra heat can discolor
R. See “Cooklng Qulde” for furlher Information.
