3 Copy
48 Xerox 6204 Wide Format Solution
Copy
3
Step 3 Scanning the Original
Follow the procedure below to scan the original.
Important • A document jam may occur if you pull or press down too hard on an original while it scans.
• To prevent document jams when copying originals that contain holes, orient the original so
that the holes feed in last.
1 Orient the original face down, with one edge
aligned with the original guide, and then evenly
insert the lead edge into the scanner. When the
scanner detects the original, it will feed it a short
distance and stop briefly, then complete the scan
automatically.
Note: Hold the original down flat with two hands (one
on either side of the arrow shown in the
graphic) while it feeds into the starting position.
Doing this helps prevent wrinkles that may
result in dark areas on the copy. The document
may jam if you release it before it stops
feeding.
Note: If the document does not feed automatically, the Scan Start mode may be set to [Manual
Start]. In this case, press the <Start> button. For more information about the Scan Start
mode, refer to "Scan Start" (P.149).
Note: The original guide can be moved to the right to scan an oversized original, or an original
with hanging holes.
Note: If a problem occurs during scanning, an error message will appear on the touch screen.
Solve the problem as instructed in the message.
2 If the scanner is equipped with front return guides, the original will exit toward the front
of the machine. You may wish to guide the lead edge of the original as it travels
toward you.
