Using CentreWare Internet Services to Configure Settings on the Machine
Xerox CopyCentre/WorkCentre 118 System Administration Guide 99
•File Server Name
• Polling Interval
• Number of Searches
• Password
• Re-enter Password
• TBCP Filter (Only available when the optional PostScript Kit is installed.)
• Tree Name
• Context Name
• Transport Protocol
•Frame Type
• Network Address
•SLP
• Active Discovery
NOTE: For more information about the options, refer to Properties in the CentreWare
Internet Services chapter of the User Guide.
5. Select [Apply New Settings] to reflect the new setting.
6. Enter the user ID and password, then select [OK].
NOTE: The default user ID is "admin" and the default password is "x-admin".
7. When the reboot message appears, select [Reboot].
TCP/IP
This page allows you to configure the following TCP/IP settings.
NOTE: Some settings on this page will only be available after you reboot the machine
from CentreWare Internet Services, or after the machine is switched off and on.
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select the plus symbol [+] to the left of the [Protocol
Settings] folder.
3. Select [TCP/IP].
4. Set up the following options to be displayed in the frame.
•Host Name
• Get IP Address
• IP Address
• Subnet Mask
• Gateway Address
