Scanning and Faxing
WorkCentre 7425/7428/7435
System Administrator Guide
150
• Batch Send
• Manual Send/Receive Default: Select the default setting for manual Fax operations.
• Fax Receiving Mode: Leave this setting at Auto Receive for unattended operation.
• Border Limit
• Auto Reduce on Receipt
• Tray for Printing Incoming Faxes
• 2 Pages up on Receipt
• 2-sided Print
• Edge Erase – Top & Bottom Edges
• Edge Erase – Left & Right Edges
• Reduce 8.5 x 11 Original to A4
• Pseudo-Photo Gradation Mode
• Box Selector – Line Setup: Enable this setting to enable Fax Folders to receive incoming faxes.
• Memory Full Procedure
• Maximum Stored Pages
• Mixed Sized Originals Scanning Mode
• Folder Receive Display (Priorities 1 through 3)
• Direct Fax: To use Direct Fax from the PCL or PostScript driver, make sure this setting is
Enabled.
14. When complete, touch Close until the Tools screen is displayed.
15. Wait several seconds for the Auto Clear service to log you out.
To Configure Fax to Folder
1. Press the Log In/Out button on the control panel.
2. Enter the System Administrator’s Login ID and Passcode if prompted (default admin, 1111), and
press Enter.
3. Press the Machine Status button.
4. Touch the Tools tab.
5. Touch System Settings.
6. In the Group column, touch Fax Service Settings.
7. Touch System Settings. Under Group, select Fax Service Settings.
8. Under Features, touch Fax Control.
9. Touch Folder Selector Setup.
10. Touch Change Settings.
11. Touch Enable.
12. Touch Save.
13. Touch Close.
14. Under Features, select Fax Received Options.
15. Touch Folder Selector Setup.
