Filter
Top Products
1/2
Service Technical Information
MODEL NO.
TV SA2151/A2118/A2110/A2018/A2010−
SUBJECT
REF.No. :G A0 125 E0Distinction Switch setting up procedure −− −
DATE :10. APR. 2001
<CONTENTS>
Setup procedure for Distinction Switch was not described in the service manuals below.
TV SA2151 09 007 420 8S1− −−−
TV A2110 / A2118 09 007 416 7S3− −−−
TV A2010 / A2018 09 007 420 5S1− −−−
Please refer to the following procedure when setting Distinction Switches.
<COUNTERMEASURE>
1. Press TEST key of a Jig remote control and set to the AGING mode.
2. Press SYSTEM key of a jig remote control and set to the Distinction Switch mode.
3. Make sure the lower part in the upper row on the screen 1:KE 1 8:SH4, are shown in∼
red as the below table. If not press the numeric key to make the items in question become
red.
Model Name Item Key
TV SA2151 SH3 7−
TV A2118 SH2 6−
TV A2110 KE2 2−
TV A2018 SH2 6−
TV A2010 KE2 2−
Items to be selected by modelFig.1
1: KE1 5: SH1
2: KE2 6: SH2
3 : I NDO1 Red7SH3:
4:INDO2 8:SH4
0123456789ABCDEF Address0F∼
101000011110001 Date 0F1 ∼
1111111111111111
0123456789ABCDEF Address101F∼
1011001000110000 Date 10F∼
Fig.2 (Example : TV SA2151)Screen shot on the distinction switch set up mode −
4. Check to see if the data of address 0-1F match the Fig3 (next page) or not.
If not, amend them as follows:
CHANNEL UP/DOWN Select appropriate data (selected data appear in red)
VOLUME UP/DOWN Change value (0 or 1)
5. After data input and/or confirmation is completed, Press TEST key to go back to the
AGING mode.
G R Code No. Access Code Modified Ser. No. Parts Schedule
−− − − − −