Filter
Top Products
29-EN
Installation
1
Slide mounting sleeve from main unit (see
Removal Procedure below). Slide the mounting
sleeve into the dashboard.
2
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the
CDA-7969R and put the Rubber Cap on the hex
bolt. If your vehicle does not have the Mounting
Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the
leads of the CDA-7969R according to details
described in the CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis
installing location.
3 Slide the CDA-7969R into the dashboard. When
the unit is in place, make sure the locking pins are
fully seated in the down position. This can be
done by pressing firmly in on the unit while
pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard.
Removal
1 Use a small screwdriver (or similar tool) to push
the locking pins to the "up" position (see above
drawing). As each pin is unlocked, gently pull
out on the unit to make sure it does not re-lock
before unlocking the second pin.
2 Pull the unit out, keeping it unlocked as you do so.
Lock pin
Dashboard
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
Hex Bolt
(Included)
CDA-7969R
<JAPANESE CAR>
Front frame
CDA-7969R
Mounting Bracket
Screws (M5 × 8)
(Included)
No Pressure Here
No Pressure Here
∗
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
CDA-7969R