Filter
Top Products
5-EN
Display Angle Adjustment
The movable display may be adjusted to 3
different angles depending upon user preference.
1 Press the F button, and when the FUNC
indicator blinks, adjust the movable display angle
by pressing button F1 (DOWN) or F2 (UP).
NOTES
• The display will close a half minute after the ignition
key is turned to the OFF position.
• The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the power
is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm under
normal operating conditions. This is not a malfunction. Do
not touch.
Setting the Front Panel closing mode
1 Press and hold the INTLZ button for at least 2
seconds.
2 Press the f UP button repeatedly to select
"CLOSE".
Each press of the f UP button changes the
modes as shown:
NOTE
If you press the DN g button the display scrolls in
reverse sequence.
3 Press the TUNE button to toggle mode between
CLOSE AUTO and MANU.
• CLOSE AUTO: The Front Panel automatically
closes when ACC is on OFF.
• CLOSE MANU: The Front Panel remains open
until closed manually.
4 When the setting is completed, press the INTLZ
button for at least 2 seconds to return to the
normal mode.
Movable display
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1 Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
NOTES
• If the MODE button is not pressed in 5 seconds after
selecting the BALANCE or FADER mode, the unit
automatically returns to the VOLUME mode.
• When the subwoofer mode is ON, its level may also be
adjusted.
2 Rotate the Audio Control knob until the desired
sound is obtained in each mode.
NOTE
Depending on the connected devices, some functions and
display indications do not work.
Adjusting Source Signal Level
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the INTLZ button for at least 2
seconds.
2 Press the f UP button repeatedly to select
"FM-LE. (FM-LEVEL)".
Each press of the f UP button scrolls the
modes as follows:
NOTE
When you press the DN g button, the display scrolls
in the reverse sequence.
3 Press the TUNE button to select the FM signal
level mode. Each press toggles between "FM-
LEVEL HI" (High) and "FM-LEVEL LO" (Low).
4 Press and hold the INTLZ button for at least 2
seconds to activate the normal mode.
→ FM-LE → REG → PTY31 → AMBER → DIM → SUB → BEEP
D-OUT ← CLOSE ← DEMO ← AUX ← SCR ← MUTE ←
→ VOLUME → BALANCE → FADER
→ FM-LE → REG → PTY31 → AMBER → DIM → SUB → BEEP
D-OUT ← CLOSE ← DEMO ← AUX ← SCR ← MUTE ←