Filter
Top Products
10
Stopping
playback
Press the stop button during playback to stop
playback. That position is stored in the memory.
DVD
CD
Video CD
Press “
L
” during playback.
• Using the PRE-STOP function (DVD,
Video CD only)
When the PRE-STOP function is used, the
position at which playback is stopped is stored in
the memory, and playback resumes from that
position.
Press “
L
” once during playback.
“PRE-STOP” is displayed.
Press “
::
::
:
” in the PRE-STOP mode.
Playback starts from the position at which it
was stopped.
Stopping playback
Tips
Turning the power on
and off
Press “POWER”.
The power turns on.
These indicate the discs for which
the function can be used.
DVD
Video CD
CD
...DVDs
...Video CDs
...Music CDs
This indicates supplementary
explanation of operation of this
system.
Caution
Turning the power on and off
When connected with an Alpine
head unit
If the DVA-5205P is connected to
anything other than the CVA-1005R/IVA-
M700R/IVA-C800R (for ex.: CVA-1000R),
the default DVD setting must be
changed. See page 36, “Custom setting
– Changing the Ai-NET settings” to
change the SETUP to CD mode and see
page 38, “Custom setting – Changing
the H.U. CONTROL settings” to change
the SETUP to ON mode before using it.
To turn the power off, press
“POWER” again.
Notes:
•
With this unit connected to an Ai-NET compatible
head unit, there will be about a 3 second delay during
power-up from the remote control. This is caused by
the systems communications being carried out by the
various components and is not a defect.
•
When connected with an Ai-NET compatible head
unit, the power cannot be turned off from the remote
control unit. Turn off the DVA-5205P’s power by
switching the head unit’s source. For details, refer to
“Operating from the head unit” (page 56).
Tips
• Reading this manual
Play Position Memory Function
• Even if you turn power off or switch the
Ignition Key to OFF during playback or
change the video source, playback will
continue from the point where playback
stopped when the power is turned ON
again.
The play position memory is released if
the disc is removed or the Reset switch
is pressed.