Filter
Top Products
66
In case of difficulty
• If operation freezes, the screen goes black or the unit should otherwise not function properly, try turning
the power off then back on. Alternatively, try the following methods in the order listed until the DVA-5205P
returns to normal playbak mode:
1) Change the source from DVD to another source then return to DVD mode.
2) Turn the car’s ignition OFF and back ON again.
3) Press the RESET button on the face of the DVA-5205P.
• This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your
system is properly connected or consult your authorized Alpine dealer.
Cause
Fuse is blown.
Monitor’s power is not turned on.
Condensation.
Remote control unit’s batteries
are worn.
Remote control sensor or
transmitter is dirty.
Monitor’s mode is not switched
to the mode you want to see.
Monitor’s parking brake cord is
not connected.
Monitor’s parking brake is not
set.
Disc is loaded upside-down.
Disc is dirty.
A disc not able to playback with
this unit is loaded.
Parental lock is set.
Setup menu is displayed.
Disc is being fast-forwarded or
fast-reversed.
Vehicle’s battery power is weak.
Monitor’s fluorescent tube is
worn.
Disc is scratched.
No disc is loaded.
Disc is dirty.
Remote control operation is not
possible.
Disc does not match regional
code number.
NTSC disc is loaded.
Protective circuit is activated to
high temperature.
Symptom
Unit does not
operate.
Operation is
unstable.
No picture is
produced.
Playback does not
start.
Picture is unclear
or noisy.
Image stops
sometimes.
NO DISC
NOT VALID
REGIONAL CODE
VIOLATION
VIDEO SIGNAL
SYSTEM IS NOT
CORRECT
HI-TEMP
Remedy
Replace with a fuse of the specified capacity. (See
installation instructions.)
Turn on the monitor’s power.
Wait a while (about 1 hour) for the condensation to
dry.
Replace the remote control unit’s batteries with new
ones.
Clean the sensor or transmitter.
Switch to the mode you want to see.
Connect the monitor’s parking brake cord and set the
parking brake.
(For details, refer to the monitor’s instructions.)
Check the disc and load it with the labeled side facing
upward.
Clean the disc.
Check if the disc is able to be played back.
Cancel the parental lock or change the rating level.
Press “SET” to turn the menu off.
The picture may be slightly disturbed, but this is
normal.
Check the battery power and wiring.
(The unit may malfunction if the battery power is
under 11 volts with a load applied.)
Replace the monitor’s fluorescent tube.
Replaced with a non-scratched disc.
Load a disc.
Clean the disc.
For some discs or playing modes, certain operations
are not possible. This is not a malfunction.
Load a disc that matches the regional code number.
Load a PAL disc.
Turn the power (main unit power when not connected)
OFF on the connected head unit and then turn the
power ON again. If the display still does not
disappear, leave the power OFF until the temperature
decreases and then turn the power ON again.