Filter
Top Products
38-EN
01GB05VPAB222R.fm
ALPINE VPA-B222R 68-02065Z87-A (EN)
With Dolby Digital, the dynamic range is compressed so that powerful
sound can be achieved at regular volume levels. This compression can
be cancelled to achieve an energetic sound with even greater power, like
the sound in a movie theater.
This function works only in the Dolby Digital mode.
Press the joystick left or right to select STD or MAX. of
LISTENING.
• Keep the volume to a level at which sounds outside the vehicle can
still be heard.
The test tones help to make the volume adjustments of the different
speakers. When levels are equal, a strong sense of presence can be heard
from the different speakers at the listening position.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the decode mode is switched.
1 Press the joystick left or right to select ON of OUTPUT.
Test tone output is repeated for each of the different
speaker channels. They will be repeated in the order
shown below.
If no operation is performed for 2 seconds, the channel
switches to the next channel.
2 Press the joystick down to select OUTPUT LEVEL.
3 Press the joystick left or right to balance the output from
all the speakers.
• If a speaker is set to off mode, that speaker’s level adjustment cannot
be made. Refer to “Speaker Setup” (page 36).
Adjusting the DVD Level
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and
PCM modes can be set.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the Decode mode is switched.
1
Check that Defeat mode is off (page 12).
2
Press and hold TA/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
3
Press the joystick up or down to select AP SETUP,
then press the joystick right.
The AP SETUP screen is displayed.
4
Press the joystick up or down to select DVD
LEVEL, then press the joystick right.
The DVD LEVEL screen is displayed.
5
Press the joystick up or down to select the desired
mode.
6
Press the joystick left or right to adjust level.
The level can be adjusted in the range of –5 to +5.
7
Repeat step 5 and 6 to set each level.
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Check that Defeat mode is off (page 12).
2
Press and hold TA/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
3
Press the joystick up or down to select AP SETUP,
then press the joystick right.
The AP SETUP screen is displayed.
4
Press the joystick up or down to select PRESET
MEMORY, then press the joystick right.
5
Press the joystick up or down to select any one of
the preset numbers (1 through 6), then press //
ENTER.
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
Achieving powerful high volume sound
STD: For powerful sound at regular volume levels
MAX.: For powerful sound at high volumes
Adjusting the speaker levels
Left Centre Right Right Surround
Left surround Left
• The adjustment range for the different speakers is
–10 dB - +10 dB.
• Adjust based on the front speakers.
01GB00VPAB222R.book Page 38 Monday, January 23, 2006 4:24 AM