Filter
Top Products
11
Instruction Manual
Specifications
Type Sealed enclosure, down-firing
Bass driver 10” (254mm) long-throw
Frequency response 30-250Hz, +/- 3dB
Amplifier power 180 RMS
Peak output 106dB in 2000 cu.ft.
Dimensions (WxHxD) 22 x 19½ x 12”
559 x 496 x 305mm
Weight 35 lbs (16 kg)
Specifications are those in effect at the time of printing. Atlantic Tech-
nology reserves the right to change specifications or designs at any time
without notice.
Painting the Cabinets
The cabinet may be painted to
blend in even better with your
room’s décor. First, clean the cab
-
inet, using an appropriate cleaner
such as non-ammonia Windex®
or diluted Simple Green®. Then
use a coat of primer, such as
Glidden® interior/exterior Grip
-
per® or Rust-Oleum® Rusty
Metal Primer. Be sure to follow
the primer’s instructions.
For the finish coat, we recommend using a latex water-based paint. You
may use a brush, pad, roller, or spray paint, depending on the type of
finish effect desired. For best results apply two light coats of the final
color. Make sure the first coat is completely dry before applying the sec
-
ond coat.
IMPORTANT:
Please don’t get paint on the amplifier. Also, don’t
paint the driver recess area of the cabinet or risk getting any paint
on the acoustical foam or the driver itself, as this may seriously
degrade the unit’s performance and void the warranty.
During painting, please protect these areas with paper and mask
-
ing (painter’s) tape. For best results, remove while the paint is still
wet.
Subwoofer Troubleshooting Guide
Once your subwoofer is set up, you should have many years of maintenance free enjoyment from your system. However, if you should encounter a
problem, refer to the following guide to help you find the solution. If a problem persists, you should contact your local authorized Atlantic Technol
-
ogy dealer.
Problem Possible Cause Possible Solution
No bass output AC power cord unplugged or Plug into a working outlet.
plugged into a non-working outlet.
Input cables not securely Check all connections, then try another
connected or defective. input cable.
Receiver/Processor's sub-out is muted, Check that receiver/processor is configured
due to incorrect configuration of speaker so that all speakers are set to "small" and
setup menu. sub is "on."
Audible buzz or hum Input cable not securely connected Check all connections, then try another
or defective. input cable.
Ground loop through antenna or Test by disconnecting antenna and/or cable
cable TV system input. system input leads. If hum goes away, install
isolation balun(s) at that point.
Specifications
RIGHT
+
-
L/MONO
-
+
OUTPUT
HIGH
LEVEL
INPUT
STDBY
RIGHT
L/MONO
LOW
LEVEL
LOWPASS
BYPASS
AUTOOFF ON
NORMAL
1800
FREQ
PHASE
LEVEL
16050
MAXMIN
STATUS
220-240V
RISK OF ELECTRIC SHOCK
DO NOT OPEN
110-120V
POWER
CAUTION
WARNING
ON OFF
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLICANCE TO RAIN OR MOISTURE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
WARNING: SHOCK HAZARD-DO NOT OPEN
AVIS:RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR