Filter
Top Products
3
I. PREPARATION OF VEHICLE INTERIOR
1. Remove the O.E.M. compartment console
currently mounted to inner roof of vehicle.
Remove (1) one # 8 X 1 3/4" screw from recess
in front of console near rear view mirror. Pull
front of O.E.M. console down to access wiring.
Disconnect all wiring from console. Pull console
forward to release rear retainers from inner roof
recess near center of vehicle. Remove console
and lay it in a safe place. See Figure 1.
2. Turn console over and place on a covered surface.
Remove plastic molded assembly from cloth covered
trim ring. Using a 7/64” drill bit, drill through the
center of the (10) ten plastic pins which secure
console together. See Figure 2. CAUTION:
Do not drill deeper than 1/2" or you may drill
through console in some areas. Using a small
chisel, carefully remove the head of the (10) ten
plastic pins. Unsnap the wiring connector secured to
clip on trim ring and separate console from trim ring.
See Fig. 2.
FIGURE 1
FIGURE 2