Filter
Top Products
9
14. Route all accessory wiring, video and audio cables, and any other added component requirements to
their respective places in the vehicle. Refer to component installation instructions for wiring
diagrams.For Suburban applications, the suggested routing of the video system cable is as follows:
• Above headliner from video system to B-pillar.
• Down the B-pillar to the floor.
• Route the separate power and ground leads from this point to convenience center located just
forward of the emergency brake pedal. Connect red power lead to an accessory controlled
source. Ground the black negative lead to the chassis.
•Route the remaining wiring ( RCA plugs, Mini AMP connector, and Remote Sensor extension )
to the video system is to be used as a television, install the antenna above the headliner per
instructions included in the video system.
15. Re-install the B-pillar cover, upper handle, and door trim. Reattach the seat belt bolt and re-torque
to manufacturer’s recommended setting. Replace trim pieces previously removed from upper and
lower seat belt.
FIGURE 13