Filter
Top Products
1010
1010
10
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
cr TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to
call the time display on the incorporated
quartz clock. The current time will appear
together with an AM or PM indication. The
display will return to the radio frequency
indication after 5 seconds.
During CD player or changer operation, the
first press of the button will call the time
display. In either case, the display will return
to the disc track indication after 5 seconds.
cs EQUALIZER BUTTON (EQ)
The EQ button applies preset sound effects
to the unit’s audio output signal. The EQ
button, when pressed, will activate one of
three operating modes (ROCK, CLAS, or
POP). When the EQ function is active, as
displayed on the panel, the bass and treble
levels cannot be changed. When the EQ
function is not active, the unit returns to the
user set bass and treble levels.
ct THEFT-DETERRENT LED
Located on the chassis behind the front
panel, a light-emitting diode (LED) will flash
when the panel is physically removed. The
flashing light serves as a visual warning to
the would-be thief that the unit has been
disabled by removal of the front panel.
cu RESET BUTTON
The RESET button is located to the right of
the theft deterrent LED. The reset circuitry
should only be activated under the following
circumstances as it will erase the time
and pre-set memories:
1.Upon initial installation after all wiring is
completed.
2.If there is a malfunction of any of the
switches on the unit, pressing the RESET
button may clear the system and return
to normal operation.
dl FRONT PANEL OPEN/CLOSE
BUTTON
This button is used to open (fold down) and
close the motorized front panel. To detach
the front panel, press the button so that the
panel folds down to the lowered position.
Grasp the release latch on the middle
underside of the panel and pull the panel
straight off of the panel mounting plate. The
mounting plate will then automatically return
to the upright position within 3 seconds, and
the theft-deterrent LED will begin to flash.
NOTES ON USE OF FRONT PANEL:
1.The front panel must be reinstalled with
the mounting plate in the upright position.
To accomplish this, first engage the left
side of the panel into the mounting plate
guide; then carefully press the right side of
the panel until it snaps into place in the
right mounting plate guide.
2.To verify correct panel installation, press the
OPEN/CLOSE button to swing the panel
assembly down, and then up into position
until it locks easily into place. If any
resistance is encountered, re-check panel
orientation in chassis mounting plate.
3.When taking the front panel with you,
please use the supplied carrying case to
protect the panel from dirt and damage.
Make sure there is no dust or dirt on the
electrical terminals on the back of the
panel as this could cause intermittent
operation or other malfunctions.
dm REMOTE SENSOR
The sensor to detect the infrared signal from
the wireless remote control is located
adjacent to the lower left corner of the front
panel. For optimum operation of the remote
control, always aim the control at this area.