Filter
Top Products
Back View
10
REMOTE CONTROL WITH
WIRELESS GAME CONTROL OPERATION
DIRECTION KEYS
M1/M2
P1/P2
SELECT
TB
A
TA
B
GAME/REMOTE
SELECTOR SWITCH
BATTERYCOVER
START
RESET
Battery Installation
Before attempting to operate your remote control, install the
batteries as described below:
1) Turn the remote control face down. Using a finger, slide
battery cover off in the direction of the arrow.
2) Install three “AAA” batteries. Make sure that proper polarity
(+ or -) is observed.
3) Align the cover tabs with the remote control and slide the
cover until it locks.
The remote control will only operate the M1/M2 Monitors. It is not
a universal remote control and will not control equipment from
other manufacturers.
WIRELESS GAME CONTROLLER FUNCTIONAL
DESCRIPTION
1. Position the GAME/REMOTE selector switch to the GAME
position.
2. Use the SELECT button (page up & page down) to display
the games (1-32). Then use the direction buttons to move the
arrow to the desired game. Press START to select the game.
3. A Key : “A Function Key” activates the jump and optional
weapons.
4. B Key : “ B Function Key” activates Bullet fire and attack.
5. TA Key : TURBO “A” Function Key.
6. TB Key : TURBO “B” Function Key.
7. Press START to begin the game. Press START again at any
time to pause the game.
8. Return the GAME/REMOTE selector switch to the REMOTE
position after use.
Two-Player Games
The game source can only be selected from the M1 Monitor.
When playing two-player games, select the GAME source on the
M1 Monitor and select the M1 source on the M2 Monitor.
When playing two-player games, use two remote controls and set
the remote controls as follows:
Player 1 (M1 Monitor) sets their remote to Game/M1/P1
Player 2 (M2 Monitor) sets their remote to Game/M1/P2.
Single player games can be played on the M2 Monitor but the M1
Monitor must be turned on and set to the GAME source. You
cannot watch a DVD on the M1 Monitor and play a game on the
M2 Monitor. When playing a single player game on the M2
Monitor, set the remote control to GAME/M1/P1 and point the
remote control to the M2 Monitor.