Filter
Top Products
16
NAVIGATION
SETTING THE NAVIGATION
1. Connect a NAVIGATION system to the AV1 or AV2 input terminals on the rear of the unit.
2. Press the MODE button to select radio mode.
3. Press the MENU button to select following picture.
4. Press the SEARCH UP/DOWN button to select NAVIGATION.
5. Press the VOLUME or button to select AV1 or AV2 that NAVIGATION system is
connected to. Each time you press this button, AV input changes as follows.
AV1 -> AV2 -> OFF
WATCHING THE NAVIGATION PICTURE
Press the NAVI button on the remote. The monitor will display the navigation picture only
and the Navigation announcement will not be heard.
The previously selected audio source will continue to play. However rear monitors (if
connected) will still display whatever you were watching before you pressed the NAVI
button.
If Navigation is selected on the Radio menu as pictured above, the monitor and rear
monitors (if connected) show the Navigation picture and the Navigation announcement will
be heard.
You are not able to watch and listen to whatever you were watching or listening to before
you selected Navigation on the Radio menu.