Filter
Top Products
128-6862A
8 of 16
cqcq
cqcq
cq EQUALIZER SELECTOR (P.EQ)
The P.EQ button applies preset sound effects to the unit’s audio
output signal. The P.EQ button, when pressed, will activate one
of the following operating modes: CLASSICS, POP M, JAZZ,
FLAT,or DSP OFF. If the bass and treble levels are changed
when the P.EQ function is active, as displayed on the panel, the
equalizer function automatically reverts to the FLAT setting. When
the equalizer function is not active, the unit returns to the user
set bass and treble levels. The FLAT selection indicates no
equalizer enhancement of the program, while DSP OFF inhibits
selection of equalizer mode enhancement.
cr cr
cr cr
cr LOCAL/DISTANT (LOC) SELECTOR
This feature is used to select the strength of the signals at which
the radio will stop during Automatic Seek Tuning. Pressing and
holding this button will select the Local setting (LOCAL will ap-
pear on the display panel) and only strong (local) stations will be
received. Pressing the button again will select the normal Dis-
tant setting (Dx will appear on the display panel). The radio will
now stop at a wider range of signals, including weaker (more
distant) stations.
cscs
cscs
cs MODE SELECTOR (MODE)
This button is used to select the radio, external (AUX) audio in-
put, or the playback mode for the CD player or remote CD changer
(if installed). Each press of the button will select a different mode
(as indicated on the display panel.
During CD player operation, this button may be used to change
to radio or remote CD changer mode (CDC) without ejecting the
disc (the indication will remain on the display panel to show
that a disc is still loaded in the unit). Press the button again to
return to integral CD player mode and resume play of the disc
from the point at which it was stopped.
ctct
ctct
ct &
cucu
cucu
cu DISC SELECT (D.UP & D.DN)
These buttons are used to increase or decrease selection of a
desired disc for play in the remote CD changer. To advance to a
higher number disc, press the D.UP button ct. To return to a
lower number disc, press the D.DN button cu. The number of the
disc in play will be shown on the display panel.
dl dl
dl dl
dl FRONT PANEL RELEASE BUTTON
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button
so that the left side of the panel is released. Grasp the released
side and pull it off of the chassis.
To re-attach the panel, position the right side of the panel in place
first and then press the left side of the panel in until the mechanism
locks it into place.
dmdm
dmdm
dm THEFT-DETERRENT LED
The theft-deterrent Light Emitting Diode (LED) is located behind
the front panel and is accessible when the front panel is removed.
The flashing light serves as a visual warning to the would-be thief
that the unit has been disabled by removal of the front panel.
-8-