Filter
Top Products
128-6862A
9 of 16
-9-
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up when attaching it
to the chassis as it cannot be attached when up-side down.
2. Do not press very hard on the front panel when attaching it to
the chassis. No more than light to moderate pressure should
be needed.
3. When attaching the front panel, make sure the right side is
correctly engaged before pressing the left side to lock it into
position.
4. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage. Make
sure there is no dust or dirt on the electrical terminals on the
back of the panel as this could cause intermittent operation
or other malfunctions.
ATTACHING THE FRONT PANEL
Release Button
DETACHING THE FRONT PANEL
Engage right
side first
dndn
dndn
dn RESET BUTTON
A RESET button is located on the front of the chassis (front panel must
be removed to access the button). The RESET circuitry is provided to
protect the microprocessor circuitry and should only be activated under
the following circumstances as it will erase the time and pre-set
memories:
1. Upon initial installation after all wiring is completed.
2. After the position of the frequency step switch on the bottom
of the chassis has been changed.
3. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and return
to normal operation.