Filter
Top Products
Changing basic settings in the settings menu
108
Ensure that all passengers in
the vehicle are sitting and re-
maining quiet.
Change to the "User Equaliz-
er" menu and call up one of the
user-defi ned equalizer settings
("User EQ 1 to 3") as described
in the preceding section.
Open the "User EQ 1/2/3"
menu as described on page
107.
Press the softkey
7 (next to
"Automatic") and follow the in-
structions on the display.
After a 5-second countdown,
you hear the teat noise and the
display intermittently shows
"Silence Please" and "Adjust-
ing".
The automatic equalizer setting
fi nishes successfully if the dis-
play shows "Adjustment OK".
The equalizer setting is saved.
Any previously stored setting
under this equalizer setting is
overwritten. The new setting
can now be called up under the
corresponding equalizer set-
ting ("User EQ 1 to 3").
➔
➔
➔
➔
Manual:
As an alternative, you can
manually create the equalizer
setting without measurement
microphone. In each of the six
frequency bands, you can select
one specifi c individual centre
frequency and fi nely adjust its
level and quality factor Q.
Insert a CD with which you are
very familiar.
Adjust bass, treble, balance,
and fader to zero.
Open the "User EQ 1/2/3"
menu as described on page
107.
Press the softkey
<
(next to "Manual").
First, select a frequency band
to be changed. First, change
the centre, then the treble, fol-
lowed by the bass.
"EQ Low 1" to "2": To change
the bass (20 to 250 Hz).
"EQ High 1" to "4": To change
the centre or treble (320 to
20,000 Hz).
The frequency spectrum is dis-
played. if you already changed
the level in another frequency
band, this change is visible in
the frequency spectrum.
➔
➔
➔
➔
➔
•
•
02_BA_Memphis_EU_eng.indd Menü10802_BA_Memphis_EU_eng.indd Menü108 03.05.2006 10:44:09 Uhr03.05.2006 10:44:09 Uhr