Filter
Top Products
28
Radio operation
FM and AM buttons
You can chose between FM and AM band (medium frequency band). Press FM or AM. Three
memory banks are available for FM. When in FM radio mode, press FM to advance to the next
FM band, FMI, FMII, or FMIII/FMT (Travelstore).
Tuning sensitivity
Press SENS for more that 2 seconds to switch between lo and dx search sensitivity. In general,
set SENS to “lo” when in metropolitan areas or where stations tend to be strong and local, and
to “dx” if in rural areas or where stations tend to be weak and distant.
Seek tuning
Press or to seek the next receivable radio station. Tuning stops at the next receivable
station.
Manual tuning
Press or and the frequency will go one channel/step in the direction pressed. Press and
hold causes continuous manual tuning.
Preset station storage
After tuning to the desired radio station on the desired band, press and hold a preset button for
more than 2 seconds to store the current frequency. Audio is muted during the storage, the
preset number appears, and a beep acknowledges the storage. The number of the selected
preset appears in the display.
Preset station selection
Press the desired preset button.
Travelstore
You can automatically store the six strongest stations in decreasing order of signal strength.
This function is especially useful when travelling. Press the FMT button for 2 seconds to activate
FM Travelstore. In the AM band, press the AMT button for 2 seconds to activate AM
Travelstore. “T STORE” appears for a moment. Starting at the beginning of the band,
Travelstore stores the six strongest stations and returns to preset 1.
Station Scan
To scan all receivable stations, press SCA. “STA SCAN” appears, then the frequency blinks
(along with the preset number if appropriate) during scanning. The unit continuously scans until
the user stops scan by pressing SCA. The scan time can be varied (see Chapter “DSC Menu”).
Preset Scan
Press PS for more than 2 seconds. “PS SCAN” appears, then the frequency and the preset
number blink during scanning. The unit scans all presets one after another. Press PS again to
cancel Preset Scan. The scan time can be varied (see Chapter “DSC Menu”).
Note on radio reception
When listening to weak or distant AM stations, adjusting the treble to minimum (-7) will reduce
noise and improve sound.
Stereo symbol
The stereo symbol turns on if a stereo station with an incoming signal of sufficient quality is
received. The unit gradually switches between mono and stereo automatically.
Valencia CM127 gb® 28.01.2004, 9:30 Uhr28