Filter
Top Products
33
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
DSC menu (Direct Software Control)
Blaupunkt’s exclusive Direct Software Control Menu has many unique features that allow you to
customize the unit to your needs and preferences.
Using the DSC menu:
1. Press MENU for 2 seconds to access the DSC menu mode.
2. Press the / controls to scroll through the DSC menu.
3. Use or to change menu settings.
4. After 8 seconds or by pressing the MENU button the unit exits from the DSC menu. All
changes are stored when leaving the DSC menu manually or automatically.
Turn-on message activation (“MSG ON”/“MSG OFF”)
Press or to turn the message on or off.
Turn-on message programming (“MSG ENTR”)
The unit can scroll a 40-character message across the display at the time of turn-on. To create
your own message:
1. Press the button. Eight hyphens appear with the first one blinking.
2. Press / to select the desired characters. If you want to put a blank space in name,
select “_”.
3. Press to locate the next character.
4. After the eighth character (the farthest right character) is completed, the first (left-most)
character of next group of eight characters begins to flash. After the fifth group of eight
characters, pressing will access the first group again.
5. Press AUDIO to store the turn-on message and to store the message.
Clock adjustment (“CLOCKSET”)
Pressing or shows the blinking time. Subsequent press of advances the hour;
advances the minutes. Press AUDIO to adjust the minute to :00. The unit begins keeping the
time when or is pressed or when the DSC menu mode ends.
Tuner timer on/off (“TMR ON”/“TMR OFF”)
The tuner timer allows the unit to go to a certain frequency at a certain time – from any audio
source. When the ignition is on and the unit off, the timer even turns the unit on and goes to the
specified frequency. Press or to turn the tuner timer on or off.
Tuner timer set mode (“TMR SET”)
1. Before entering the DSC menu, tune in the radio frequency to be activated by the timer.
2. Access the DSC menu mode and scroll to “TMR SET” by pressing or .
3. Press or to enter the timer adjustment mode.
4. Select the time at which the unit should switch to this station by pressing the button to
adjust the hours and the button to adjust the minutes. Press AUDIO to adjust the
minutes to :00.
5. To store the station and the time, press MENU.
Radio Monitor (“RM ON” / “RM OFF”)
Allows the radio to play during tape winding. If this feature has been activated, the RM icon
appears when a tape is in use. Press or to turn Radio Monitor on or off.
Blank skip time (“BSKPTIME”)
When the unit reaches a blank section of tape, it can automatically fast-forward to the next
recorded section. Use and to chose a minimum amount of blank time before blank skip
begins from between 4 to 20 seconds.
Recommendation: Classical music listeners may want to specify a longer blank, so that the unit
doesn’t mistake soft passages for blank spots.
Valencia CM127 gb® 28.01.2004, 9:30 Uhr33