Filter
Top Products
Augsburg CR 24
22
Autoreverse function
(Switching tracks during playback)
• Press FR and FF at the same time.
At the end of the tape, the unit will automati-
cally switch to the other track.
Note:
If there is too much tension on the cassette
tape during playback, the set may switch to
the other track by itself. In this case check the
condition of the tape. Sometimes it helps to
rewind the cassette tape completely.
Care of your audio equipment
We recommend that you use only C60/C90
cassette tapes in your car radio. Protect your
cassettes from dirt, dust and temperatures
exceeding 50 °C.
During cold weather, allow cold cassettes to
warm up somewhat before playing them in
order to avoid uneven tape transport. Opera-
ting problems and sound distortions may
occur after approximately 100 hours of play-
ing time and are caused by dust particles
which adhere to the rubber roller and the
audio head.
Use a cleaner cassette to remove normal dirt
build-up. If more dirt than usual has accumu-
lated, use a cotton bud dipped in rubbing
alcohol to clean these parts. Never use any
hard tools.
Appendix
Technical data
Amplifier:
Output power: 2 x 10 W RMS power ac-
cording to DIN 45324/3.1
into 2 Ω
FM:
Sensitivity: 0.9 µV at 26 dB signal-
to-noise ratio
Frequency
response: 35 - 15 000 Hz (-3 dB)
Cassette:
Frequency
response: 40 - 14 000 Hz (-3 dB)
Subject to modifications!