Filter
Top Products
Augsburg CR 24
18
Adjusting the station search
sensitivity
You can adjust the sensitivity of the automa-
tic station search.
For this,
• press lo.
When “lo” is visible in the display, then
only those stations with relatively strong
signals will be picked up (low sensitivi-
ty).
When “lo” is not visible in the display,
then stations with weaker signals will
also be picked up (high sensitivity).
Stereo - mono switch
You can switch to mono when the reception
conditions are only poor:
• Press lo for approximately 2 seconds.
During mono reception the stereo sign
will go out in the display.
Each time the car radio is switched on, the
reception will automatically be set to stereo.
The radio will automatically shift to mono
when the reception conditions are poor.
Changing the memory bank
You can shift between the memory banks I, II,
III and T to store and recall the stored sta-
tions.
The selected memory bank is indicated in the
display.
• Press FM•T until the desired memory
bank is indicated in the display (press
repeatedly if necessary).
Storing stations
For each memory bank (I, II, III, T) you can
store up to six stations using the preset
buttons 1, 2, 3, 4, 5, 6.
• Select the memory bank by pressing
FM•T.
• Use the rocker switch to tune in a stati-
on (either automatically or manually).
• Press the desired preset button and
hold it. First the station will be muted
and then becomes audible again (after
approximately 2 seconds).
Now the station has been stored in the re-
spective memory bank.
The activated preset button is indicated in the
display.
Radio operation
With this car radio you can receive FM fre-
quencies ranging from 87.5 to 108 MHz.
Station search
• Press
/ , the car radio will then auto-
matically tune into the next station.
If you hold the upper or lower part
/ of the
rocker switch depressed, the search function
will forward quickly in the corresponding di-
rection.
Station search
up
down in
short intervals
down
up in
short intervals
Manual station search << >>
• Press << or >>, the frequency will then
move up or down in short intervals.
If you hold the rocker switch depressed, then
the frequencies will move up or down more
quickly.