Filter
Top Products
E - 3
DIN REAR-MOUNT (METHOD B)
Installationusingthescrewholesonthesidesoftheunit.
Fasteningtheunittothefactoryradiomountingbracket.
1. Select a position where the screw
holes of the bracket and the screw
holes of the main unit become
aligned (are fitted) and tighten the
screws at 2 places on each side.
2. Screw
3. Factoryradiomountingbracket.
4. DashboardorConsole
5. Hook(Removethispart)
Note: the mounting box, outer trim ring,
andhalf-sleevearenotusedformethodB
installation.
5
2
4
3
2
5
a. Frame
b. Insert fingers into the groove in the
front of frame and pull out to remove
the frame. (When re-attaching the
frame, point the side with a groove
downwardsandattachit.)
c. Insert the levers supplied with the unit
into the grooves at both sides of the
unitas shown in figure until they click.
Pulling the levers makes it possible to
removetheunitfromthedashboard.
Trim Plate Installation:
Push the trim plate against the chassis until it is fitted.
You must do this before you install the front panel, otherwise it can't be attached.
Removing the unit
a
b
c